Hey great news, you're in luck.
We're currently accepting offers on Atom Pro Package - 3 Wheel . To submit your offer simply click the "Make Offer" button below and we'll get back to you right away and let you know if we can accept it.MAKE OFFER
|Heat Molding Technique|
|Heat Molding Technique||- Remove wheels and bearings - Loosen laces but tuck them into the boot - Loosen ALL the frame mounting bolts by 2 full turns - Preheat the oven to 180 degrees - If the oven doesn't go that low, set at lowest setting and keep the oven door cracked open - Put the skates in the oven upright on the center rack making sure they aren't touching each other - Set timer for 10 min. - Pull out the boot and squeeze the heal to see if they are pliable. - If not pliable, return to the oven until they are BUT check every minute (60 seconds) - Once pliable, your ready to put your foot in the boots - If the boots are too hot then wait 30 seconds and try again. Don't burn yourself. - Lace up your skates as if you were going to go skate - If you wear an ezfit or socks, make sure you're wearing them when you heat mold - DO NOT STAND UP - Stay seated with your knees over your toes in the "skater position" and remain there until the boots cool to room temperature.|
|Bearings||Bionic Abec 7|
|Wheels||Atom Matrix Green|